Cutting Openings Shipping Container side can be done with common tools

The addition of most of the customization box designs windows, doors, vents, or even open a side wall. Cutting Cor-Ten steel bar is not as easy as logging can be done in a number of different tools that may be available on a typical handyman & # 39; s toolbox.

First and foremost, to protect yourself while working with tools. No matter what method you select, cut steel is very sharp; Wear a pair of heavy leather gloves, like those of the welding. During the cutting operation of sparks and metal dust, wear safety goggles! The devices sound and the steel shipping container will increase noise, wear hearing protection is good! Wear a large, long-sleeved shirts, long pants. I know it's not always pleasant but it sure beats the hot metal shavings landing on you. Speaking landing when containers are constructed of 12 mm steel, about 1/8 "inch thick. A large chunk of this stuff, like a door is heavy, be careful when you finish the cut to make sure that the heavy piece of metal razor-sharp jagged edges will not fall towards and injury.

First, use a Sharpie type marker clearly draw the edge of the opening in the container made of steel. If the cutting opening box or no can not create common practice then, you can use the saws-all or reciprocating saw with a heavy steel blade save yourself some frustration here, do not buy cheap blades, you & # 39;.. cost reasons, it is difficult to work and want more heavy-duty blades available drill a hole on the inside of the line to open the candidate is sufficiently large blade, place the blade in the slot and begin to cut along the line.

you can also use a skill saw a good meal knife. to start the cut for the first time adjust the top of the blade to get the nomination line up. Lift the rear of the skill saw up until the blade leaves the surface of the tank and start the blade, the blade slowly to ease off the mark until the blade cuts through the steel, and then follow the line. You & # 39; ll need to repeat this process when it comes to corners as a skill saw is not running. Do not panic in case wanders off the line a little to one cutting methods, any errors can easily be fixed.

Who cut this type of steel to be more regularly available in a torch or the final field cutting, plasma cutting tool in your arsenal. They are much faster and simpler than a saw, and far less fooling around bends. You can rent these devices at most equipment rental places, but in practice, some scrap metal before you start cutting into the tank.

While difficult work, cutting openings containers are not difficult and can be achieved in any number of tools, just do it – gently and easiest method will come to you.

Source by JP Carrico

Leave a Reply

Your email address will not be published. Required fields are marked *